Welcome Guest. ( logon | register ) | ||||||
|
|
|
| Topic Tools | Message Format |
Author |
| ||
Rolex Date registered: Dec 1899 Location: Vehicle(s): | Help iwith a few wires Can anyone tell me where these few wires go? (DSC00200.JPG) (DSC00201.JPG) Attachments ---------------- DSC00200.JPG (143KB - 0 downloads) DSC00201.JPG (146KB - 0 downloads) | ||
#51831 | |||
Author |
| ||
cmitch Expert Date registered: Apr 2006 Location: Ala-Tenn Vehicle(s): 2002 ML320, 2005 S430 4Matic, 2010 F150 Super Crew Posts: 3412 | RE: Help iwith a few wires Do you always remove your fuse block and wiring harness when working on your car? Disconnecting the battery cable would be much easier. | ||
#51874 - in reply to #51831 | |||
Author |
| ||
BenzDieselTuner Date registered: Dec 1899 Location: Vehicle(s): | Re: Help iwith a few wires tell me dammit! | ||
#51917 - in reply to #51831 | |||
Author |
| ||
shrimpton Date registered: Dec 1899 Location: Vehicle(s): | Re: Help iwith a few wires Did you use a couple of steel rims as cable drums?. | ||
#53187 - in reply to #51831 | |||
Author |
| ||
NZ Benz Expert Date registered: Apr 2006 Location: New Zealand Vehicle(s): 1993 300SEL/S320 Posts: 2555 | Re: Help iwith a few wires Rolex - 11/6/2006 8:11 PM 80 Pounds was the weight of the last one I sent out. (Front to back entire harness) Thats quite a bit, but when you think if they wired everything with copper it's about right, almost makes recovery of the copper for scrap value worth it, well not quite. | ||
#53192 - in reply to #51917 | |||
Author |
| ||
shrimpton Date registered: Dec 1899 Location: Vehicle(s): | Re: Help iwith a few wires The wiper motor must hold a half pound or so of copper, but 80lb in the harness alone...shiite!. | ||
#53284 - in reply to #51831 | |||
« View previous thread :: View next thread » |
|
|