|
Nino
Date registered: Dec 1899 Location: Vehicle(s):
| 83 126 hard shake after warmed up
This has been going on for a little while now. When I let the car sit for a couple of days, start, idles fine. Minutes later idle deteriorates as if I'm not running on all cylinders. I was at a stop light yesterday, just after leaving the house. It would seem to me that pressure had built up sufficiently to cause the "shakes". If it sits over night, shakes when started. When I apply throttle, smooths out. I have cracked the injectors one at a time, all make it worse. RD bolt adjusted. Purged new filters, hoses, clamps. Any help, please?
|
|
|
|
BenzDieselTuner
Date registered: Dec 1899 Location: Vehicle(s):
| Re: 83 126 hard shake after warmed up
the tank screen may be clogged, causing you to lose fuel pressure..... |
|
|
|
Nino
Date registered: Dec 1899 Location: Vehicle(s):
| RE: 83 126 hard shake after warmed up
This occurs at all fuel tank levels. Will swap feed and return lines shortly, probably tomorrow when replacing "v" belts. Primary filter clear as a bell three weeks after purge. Don't recall shake during purge tho. Having an estimate done for removal of resonators in a few hours. This shake is inconsistent. Thanks. |
|
|
|
Nino
Date registered: Dec 1899 Location: Vehicle(s):
| RE: 83 126 hard shake after warmed up
Since many "colorful" adjectives, and very hot hands, may have a solution. RD bolt adjusted to point of falling out. The flat cone shaped "o" ring seemed to be on backward, my fault. Inverted, reinstalled, readjusted...SO FAR SO GOOD |
|
|
|
BenzDieselTuner
Date registered: Dec 1899 Location: Vehicle(s):
| Re: 83 126 hard shake after warmed up
good! keep us posted..... |
|
|
|
Nino
Date registered: Dec 1899 Location: Vehicle(s):
| RE: 83 126 hard shake after warmed up
Still good, now replacing V belts, have rounded off one of the nuts necessary to adjust P/S unit. I've loosened this previously. Taking break. |
|
|