Welcome Guest. ( logon | register ) | ||||||
|
|
|
| Topic Tools | Message Format |
Author |
| ||
blu60 Member Date registered: Oct 2017 Location: East Texas, USA Vehicle(s): 2016 G550, 2007 Land Cruiser, 1996 LX450, 1973 LR Posts: 12 | CAN Bus question 2016 G550 CAN Bus help Good day all: I am going to install a switch panel that requires three 12V triggers. Ignition, high beams, and side marker lights. Has anyone any experience with: http://www.canm8.com/can-bus-interfaces/multi-output-interfaces/can... and if so where would I get the signals for this interface for this wiring harness that clamps around the Hi and low CAN Bus (instructions say it’s near the ignition key but that’s it) http://www.canm8.com/cannect-contactless-reader/canm8-cannect-conta... The switch panel I am using is: http://www.switchpros.com/ I appreciate any help. | ||
#240013 | |||
Author |
| ||
thebigblue Date registered: Jan 2012 Location: Vehicle(s): | RE: CAN Bus question No experience with this - but IMO you are complicating things, why not use 3 normal relays spliced into the wire harness, ignition signal can be found at the radio at the rest is simple...? | ||
#240042 - in reply to #240013 | |||
Author |
| ||
blu60 Member Date registered: Oct 2017 Location: East Texas, USA Vehicle(s): 2016 G550, 2007 Land Cruiser, 1996 LX450, 1973 LR Posts: 12 | Re: CAN Bus question Thanks for the response, this is actually a simple addition that does not interfere with the factory wiring harness in any way. The Hi Lo wires for CAN bus B are brown and brown/red and are by the ignition. Will post after it's installed and tested. | ||
#240199 - in reply to #240013 | |||
« View previous thread :: View next thread » |
|
|